User Manual

UK
CHarging tHe Headset
1. Connect the mini-USB port on the Travel Charger
to one of the following:
- The supplied car charger (and plug the charger
into your car’s cigarette lighter)
To a USB cable connected to any USB port on a
powered-on computer (charge time is longer
when connected to a PC)
2. Insert the Jabra GO™ headset into the travel
charger.
3. The headset LED shows the current battery level:
red (low), yellow (medium) or green (full). Allow
the headset to charge until it lights yellow or
green before continuing (usually the headset
ships with a sufficient partial charge).
Pairing tHe Headset witH
YOUr mObile PHOne
1 Press and hold the multifunction button on your
(powered-off) headset for about 4 seconds—
until its LED lights a constant blue, which
indicates that the headset is in pairing mode. (If
the headset is already turned on, then pressing
this button for 4 seconds will turn it off after four
green LED flashes; if you see this, then repeat the
4-second press to turn it back on and put it in
pairing mode.)
4 sec.
2. Use the menu system of your mobile phone to
put it into Bluetooth-pairing mode (see also your
mobile-phone documentation).
3 Your mobile phone should now show a list of
found devices. Use its controls to select the
Jabra GO™ XXXX device. The phone will then ask
for the headset’s pass code, which is 0000 (four
zeros) for all Jabra GO™ headsets. Enter this code
into your phone and commit the code (e.g., by
pressing the OK button).