User's Manual

Using GN 9010
Answering and making phone calls with GN 9010
15. Put on your headset.
16. Set the headset/handset button on top of base unit in headset position (see fig. 5).
17. Pick up handset (or if available on your terminal press the headset button).
18. Answer or make a call.
19. You can now move freely up to 10 meters away from the base unit, depending on the environment in
your office building. If you move out of transmission range, GN 9010 lets you know by means of a
beep every 10 seconds in your headset.(see Technical Data)
20. To end call, put down handset.
Functions on the headset
Adjusting the volume
21. To increase or reduce volume in your headset, press successively on the upper (+) or lower (-) part of
the oval volume control (VII) on the headset. When the volume reaches maximum or minimum, you will
hear a beep in your headset. (see Technical Data)
Muting the microphone
22. To talk without your caller hearing you, press the mute button (VI) on the headset. You are still able to
hear your caller. When the microphone is muted, you will hear a beep every 3 seconds in your
headset. (see Technical Data)
Powersave
23. When GN 9010 is out of range, you will hear a beep every 10 sec. When returning into range again,
the headset will link up automaticly. The headset can be turned off by pressing simultaniously on the
upper and the lower part of volume buttom. You will hear a long deep tone. You can turn the headset
on again by pressing upper and lower part of volume buttom, and you will hear a shot beep.
Charging the battery
24. When GN 9010 is not in use, place the headset in the base unit. Ensure that the on-line indicator is
switched off. If the on-line indicator is still on, press the headset/handset button.This ensures optimum
battery lifetime. When placed in the base unit, the battery charging indicator (V) automatically lights up
and the headset is charged. It takes 1½ hours to fully charge the battery of an GN 9010. A fully
charged battery provides 2 hours of talktime. If battery power gets too low, GN 9010 lets you know by
sending a beep every 20 seconds in your headset. (see Technical Data)
Pairring/Bonding
25. To make the headset work, it must be pairred with the base unit. The base unit and the headset will be
pairred when delivered. If you wish to use the headset with e.g. a mobile telephone, it must be pairred
with the headset.
Base unit
Press the headset/handset button for more than 3 seconds. The LED on the base unit will blink when
the button is released to indicate that the base unit is in pairring mode.
Headset
Turn the headset off and on again by pressing the Bluetooth button and simultaniously on both upper
and lower part of the volume button. You will hear a beep (for 2 seconds) in the headset and the LED
will light up.
When both units are in pairring mode, the link will be established after 30 seconds.
When pairring with a mobile telephone, see the user guide for the telephone. The headset is put in
pairring mode as described above.
Troubleshooting
If you do not get a dial tone:
• Check that all cords and jacks are connected correctly.
• Check that the power unit adaptor is plugged in and has power.