User's Manual

4
6. Turning your headset on and o
Press the answer/end button until you see a burst of blue ashes to turn on
your headset
3 Sec 3 Sec
Press and hold the answer/end button until you see a burst of blue ashes to
turn o your headset.
Please note that the LED indicator light turns o after 1 minute to save
battery. To check if the headset is still on and connected, tap the answer/end
button once. The indicator light should ash back with two single ashes if it
is still on and connected.
7. Pairing it with your phone
Headsets are connected to mobile phones using a procedure called ‘pairing’.
By following a few simple steps, a phone can be paired with a headset in a
matter of minutes.
To pair the Jabra BT2020 with your mobile phone, just follow these three
easy steps:
1. Put the headset in pairing mode
When you turn on your Jabra BT2020 for the rst time, the headset will
automatically start up in pairing mode – i.e. it is discoverable for your
phone. When the headset is in pairing mode, the LED indicator light is
solid blue.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT2020
Follow your phone’s instruction guide. First make sure that Bluetooth is
activated on your mobile phone. Then set your phone to discover the
headset. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’
menu on your phone and selecting the option to ‘discover’ or ‘add’ a
Bluetooth device.
3. Your phone will nd the Jabra BT2020
Your phone will then nd the headset under the name: Bluetooth
headset. Your phone then asks if you want to pair with it. Accept by