User's Manual

6
REL EAS E YO U R J A BRA
7
Jabra BT5010 Bluetooth headset
5. The sliding boom arm
The sliding boom arm is used for answering and
ending calls, but will also give an increased audio
quality when extended.
To answer an incoming call just extend the boom
arm to an open position and to end to call slide the
boom arm back to a closed position.
The Jabra BT5010 can of course be used with the
boom arm in both positions, but will provide the
best audio quality when in the open position.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT5010
Follow your phone’s instruction guide. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and selecting the
option to ‘discover’ or ‘add’ a Bluetooth device.* (See example from a
typical mobile phone in g 3).
Fig 3
For optimal performance, wear the
Jabra BT5010 and your mobile phone
on the same side of your body or within
line of sight. In general, you will get
better performance when there are no
obstructions between your headset
and your mobile phone. (See g 5)
3. Your phone will nd the Jabra BT5010
Your phone then asks if you want to pair with it. Accept by pressing
‘Yes’ or ‘OK’ on the phone and conrm with the passkey or PIN = 0000
(4 zeros). Your phone will conrm when pairing is complete. In case of
unsuccessful pairing, repeat steps 1 to 3.
4. Wear it how you like it
The Jabra BT5010 is ready to wear on your right ear. If you prefer the left, pull
out the earhook and rotate and insert as shown. (See g 4).
Fig 4
Fig 5
6. How to…
Answer a call
• Tap the answer/end button on your headset to answer a call
or
• Open the sliding boom arm to answer the call
End a call
• Tap the answer/end button to end an active call
or
• Close the sliding boom arm to end an active call
Make a call
• When you make a call from your mobile phone, the call will (subject to
phone settings) automatically transfer to your headset. If your phone
does not allow this feature, tap on the Jabra BT5010’s answer/end
button to transfer the call to the headset.
Reject a call*
• Press the answer/end button when the phone rings to reject an
incoming call. Depending on your phone settings, the person who called
you will either be forwarded to your voice mail or hear a busy signal.
0.495