User's Manual

BT 300 User Manual
3 of 6
I BT300 Bluetooth Headset Operation---Preliminary
1. The battery must be charged before using.
2. To charge battery plug charger connector into rectangular Charge Jack located on edge of housing
opposite microphone. (Note that the headset is not functional while charging). The LED will stay red
during charging and go green when charging is complete (and the charger is still plugged in).
3. The headset is supplied for use on the right ear. For left ear use open the ear loop 90 degrees from the
closed position, carefully snap ear loop off of hinge, rotate 180 degrees and snap back onto hinge.
II Pairing with Mobile Phone (Mobile phone must be Bluetooth compatible.)
(Note: Pairing must be done every time the headset establishes a link with a different mobile phone or other
Bluetooth compatible device)
1. Verify power of mobile phone to be paired with is ON and phone is within 10 feet of headset.
2. Headset must be powered off. Press and hold On/Off button for more than 5 seconds to switch headset
to pairing mode. Green LED is constantly ON.
3. The green LED will flash fast ON & OFF when Bluetooth pairing has been completed.
4. If pairing fails, the green LED will go OFF.
III Receiving an Incoming Call
1. Place the headset on your ear after switching it ON, placing the earhook over your ear, and close the
earhook so the receiver is close to your ear. The microphone should be pointed toward your mouth.
2. If there is an incoming call while the headset is ON and the devices are paired, the call will
automatically be answered by the headset. The Incoming Call Alert is 1 second of 700 Hz Warble
Tone.
3. When on a call, the green LED will flash at a rate of 1 second.
4. To adjust the Receive Volume Up, momentarily press the upper end of the rocker switch one or more
times until the desired level is achieved. A ½ second 2 kHz beep will be heard when the max volume is
reached.
5. To adjust the Receive Volume Down, momentarily press the lower end of the rocker switch one or
more times until the desired level is achieved. A ½ second 2 kHz beep will be heard when the min
volume is reached.
IV Making an Outgoing Connection
1. If the headset is powered up, dialing can be done from the cell phone or by Voice Dialing if available.
2. Press the Function Button for more than 2 seconds and release. Dialing can be done from the cell
phone or by Voice Dialing if available.