User's Manual

16
17
Screen display
To conserve battery life, the remote control has a Standby feature
that automatically turns off the display after 20 seconds of non-
use. Whenever the display is dark, simply press any button on
the keypad to awaken the display and then perform the desired
action.
Remote control performance
The remote control performs best when buttons are pressed
one step at a time rather than in rapid sequence. When adjusting
volume, for example, briefly press a button as described below
and wait a short moment for the beep tones to be heard be-
fore continuing. This tip applies to all button use but is especially
relevant to volume adjustments.
The first time you press a button on the remote control will ac-
tivate it from standby only. You need to press one more time
to make the intended changes (e.g. volume increase, program
change, etc.).
Operating range
The Remote control operating range is
approximately 100 cm (40”). In the event
that you cannot read out the status on
the remote control, hold the remote con-
trol in front of your chest, as it is shown
in the picture.
In the event that the remote control can-
not read out the status of the hearing
instruments, search icons will appear
on the remote control. Hold the Remote control as shown above to
establish contact with both hearing instruments.
Searching for both hear-
ing instruments
Searching for right hearing
instrument
Connected to left hearing
instrument