User Manual

12 13

1. Make sure Phone Clip+ is turned on. Your hearing instru-

ments must be OFF – this is done by opening the battery

door on the hearing instrument(s).

2. Remove the silver cap from the Phone Clip+. With the tip of

a pen or similar object, press the small white pairing but-

ton one time on the back of your

Phone Clip+ (see picture to

the right). The LED will now

blink yellow every 2 seconds

to indicate that is ready to be

paired to your hearing instru-

ments. Your Phone Clip+ will

remain in pairing mode for 20

seconds.

3. While pairing mode is active,

close the battery doors on

both hearing instruments and make sure they are ON. A suc-

cessful pairing will be indicated by an audible melody played

in both hearing instruments.

Bluetooth Pairing

If your mobile phone is Bluetooth-enabled and supports the ap-

propriate proﬁles, it can communicate with the Phone Clip+ only

after completing two simple procedures: pairing and connecting.

The pairing procedure allows you to control which Bluetooth

devices are permitted to communicate with each other. It needs

to be completed only once for each device you wish to use with

your Phone Clip+.

You can pair up to 8 Bluetooth devices with the Phone Clip+, but

only 2 Bluetooth devices can be connected/active at a time.

The pairing procedure is described in the following section.

Once a mobile phone is permitted to communicate with the

Phone Clip+ by the pairing procedure, the connection procedure

conﬁgures the device to actually output its audio signal over the

Bluetooth connection. This procedure is also described in the

following section.

Pairing to your mobile phone

The pairing procedure is controlled by your mobile phone. Differ-

ent mobile phones have different menu structures. You should

therefore refer to your mobile phone’s manual if you cannot