User Manual

12
13
Bluetooth Pairing
If your mobile phone is Bluetooth-enabled and supports the
appropriate profiles, it can communicate with the ReSound Unite
Phone Clip only after completing two simple procedures: pairing
and connecting.
The pairing procedure allows you to control which Bluetooth
devices are permitted to communicate with each other. It needs
to be completed only once for each device you wish to use with
your ReSound Unite Phone Clip.
You can pair up to 8 Bluetooth devices with the Phone Clip, but
only 1 Bluetooth device can be connected at a time.
The pairing procedure is described in the section which follows.
Once a mobile phone is permitted to communicate with the
ReSound Unite Phone Clip by the pairing procedure, the connec-
tion procedure configures the device to actually output its audio
signal over the Bluetooth connection. This procedure is also de-
scribed in the section which follows.
Pairing to mobile phone
The pairing procedure is controlled by your mobile phone.
Different mobile phones have different menu structures. You
should therefore refer to your mobile phone’s manual if you
cannot complete the pairing procedure with the generic steps
described here.
3. While pairing mode is activated, close the battery doors of
both hearing aids and make sure they are ON. A successful
pairing will be indicated by an audible melody played in both
hearing aids. You are now ready to use the ReSound Unite
Phone Clip!
ON and OFF
To turn ON your ReSound Unite Phone Clip, press and hold the
multifunctional button (5 on page 9) for about 1 second until you
see the LED indicator displaying a solid blue light. The blue light
will be on for 4 seconds.
To turn it OFF, press and hold the multifunctional button for about
3 seconds until the LED indicator flashes quickly 4 times and then
goes dark.