Installation Guide

INSTALLATION GUIDE
ELECTRONIC LED DRIVER
INPUT VOLTAGE NOTE!
The input voltage: 120VAC to 277VAC
ENSURE to power the driver with the correct voltage!
200619 INSTALLATION GUIDE | ELECTRONIC LED DRIVER (96W, 200W & 300W) | 1 OF 2
Knockouts
Screw
Screw
Screw
REMOVE WIRING COVER. WIRE DRIVER.
3
Pop off cover to access wiring compartment.
Remove knockouts with hammer and punch.
Aach load and control. Only use copper wiring. Refer to
‘System Diagrams’, and installaon guides.
4
TURN POWER ON AT CIRCUIT BREAKER
Install Addional Components, Verify Connecons and turn
main power ON at breaker.
Turn power OFF at circuit breaker and verify all connecons.
Review WIRING and TROUBLESHOOTING
SYSTEM WORKING IMPROPERLY?
QUICK SPECS
Input Voltage
Output Voltage
Maximum Load
Operang Temp
Environment
See Product Label
-40° ~ 140°F (-40° ~ 60°C)
Dry and Damp Locaon / Indoor
GENERAL
This LED driver is to be installed Indoor in accordance with
Arcle 450 of the Naonal Electric code (N.E.C.) . The LED driver
must be installed in a well- venlated area free from explosive gases
and vapors. Proper operaon requires the free flow of air. Only a
qualified electrician should install this hardwired LED driver.
PRECAUTIONS BEFORE INSTALLING
Check the label and ensure the LED driver has the proper input
voltage, output voltage and waage for the job. Check the wire color
to ensure they match the wiring diagram on this instrucon sheet.
MOUNTING
Select a suitable locaon capable of supporng the weight of the
LED driver.
INPUT CONNECTIONS/GROUNDING
Remove the wiring compartment knockouts and install strain reliefs.
With power turned off, route the input wires through a strain relief.
Plug Neutral, Live and grounding wires into the each terminal of white,
black and green wires from LED driver respecvely.
The LED driver MUST be grounded
in accordance with the N.E.C.
OUTPUT CONNECTIONS
Bring the lamp wires through the open knockout.
Single-channel output models:
Plug the LED positve (+) wire into terminal of red wire from LED driver.
Plug the LED negatve (–) wire into terminal of blue wire from LED driver.
Mul-channel output models:
Refer to their unit label and specificaon for each output connecon.
Please note interconnecon of outputs are not permied.
ON
OFF
ON
OFF
ON
OFF
2
INSTALL COMPONENTS
2) Fixture1) LED Driver
24V
VDC
INSTALLATION
1
TURNING OFF POWER
WARNING: Electric Shock Hazard. May result in serious injury or death.
Turn power OFF at circuit breaker prior to installaon.
ON
OFF
ON
OFF
ON
OFF