Product Manual
XRS-370C
68
FITTING THE CONTROLLER MICROPHONE
Plug the 8 pin plug into the socket on the front of the main unit or alternatively
you can use the adapter and extension cable supplied with the radio. If the main
unit is not easily accessible this adapter will allow you to bring the microphone
socket to a more convenient position. Attach the microphone clip to a convenient
location near your driving position using screws. Slide the bollard on the back of
the microphone into the clip to secure it.
DC POWER CONNECTION
The radio is designed for 13.8 volt DC, negative earth installations only (i.e. Where
the negative terminal of the battery is connected to the chassis or frame of the
vehicle).
There are two recommended methods of installation.
RADIO REMAINS ON WHEN THE IGNITION SWITCH IS OFF
Connect the radio’s negative (black) lead to the vehicle’s chassis, or if preferred,
directly to the battery’s negative terminal. The radio’s positive (red) lead should be
connected via the 2 amp fuse to the battery’s positive terminal.
Alternatively, the positive lead could be connected into the fuse box at a point
that has +13.8 volts continuously available (on the battery side of the ignition
switch) via the 2 amp fuse.
Radio remains ON when ignion switch is OFF
RED
Fuse
BLACK
Chassis
Car baery
Ignion Switch
To Radio