Product Manual

The following characters are available:
A B C D E F G H I J K
L M N O P Q R S T U V
W X Y Z
0 1 2 3 4 5 6 7 8 9
SPACE * -
Repeat the steps above to add ALPHA labels to other SelCall
Idents currently stored in memory.
To exit the mode, briefly press the CALL button (or simply
wait 10 seconds and the Call function will time out). The radio
will return to normal operation.
To display the Alpha labels of incoming SelCalls, the radio
should be left in Alpha mode. Any incoming SelCall that does
not match those in the memory will display -NEW-. To display
the SelCall Ident of that caller, briefly press then
to return to the Numeric Mode.
RECEIVING SELCALLS
When your radio receives its SelCall Ident, an alarm will sound
to alert you to the call and the symbol will be displayed
along with the SelCall Ident or ALPHA label of the caller.
Initially the alarm will beep urgently at 2 beeps per second,
then, if the call is not answered, it will slow to around 1 beep
every 3 seconds. It will then continue to beep indefinitely until
you cancel it.
To return the call
Press and hold the CALL button for a few seconds until
the radio beeps. The callers SelCall will be sent back
to the caller.
To cancel the alarm
Briefly press the PTT switch. The alarm will be cancelled and
the channel will be open for normal communication. You can
now talk on the channel in the usual way.
QUIET MODE
The Quiet Mode mutes the receiver to prevent incoming
signals from being heard in the speaker until your SelCall
Ident is received. This allows you to monitor a busy channel
for personal calls without being disturbed by unwanted
signals. Once your SelCall Ident is received, the Quiet Mode is
cancelled and all incoming signals are heard in the speaker.
Setting up QUIET mode
To setup the Quiet mode you must first ‘tag’ the channels
that you want to stay Quiet, then activate the Quiet Mode.
Once the Quiet mode is activated, the tagged channels will
remain quiet to all incoming signals unless your SelCall Ident
is received. Channels that are not tagged will remain open to
all signals and will operate normally.
To tag individual channels for QUIET operation
1. Select the required channel.
2. Press and hold the key until the radio beeps. ‘Q’ will
appear to the left of the channel number indicating the
selected channel is now tagged for Quiet operation.
To remove the QUIET tag from individual channels:
1. Select a channel that has been tagged for Quiet operation.
‘Q’ will be displayed.
2. Press and hold the key until the radio beeps. ‘Q’ will
disappear indicating this channel is no longer tagged for
Quiet operation.
Activating QUIET mode
1. Select a channel that has been tagged for Quiet operation
(you cannot activate the Quiet mode unless a ‘tagged’
channel is selected). ‘Q’ will be displayed on that channel.
2. Briefly press the key. will appear on the display.
The Quiet mode is now activated and all channels that were
tagged for Quiet operation will now be operating in the
Quiet mode.
Deactivating QUIET mode
1. Select any channel that has been tagged for Quiet operation.
‘Q’ and will be displayed on that channel.
2. Briefly press the key. will disappear from the
display and all channels that were tagged for Quiet
operation will now operate normally again.
TX3350 INSTRUCTION MANUAL PAGE 17