Product Manual

3. Press and hold the
LEVEL
key until the radio beeps.
The right-hand digit of the SelCall Ident will flash.
4. Press the or keys to select the required number
in the flashing digit position.
5. Briefly press the
LEVEL
key again to select the next
digit position.
6. Repeat steps 4 and 5 to enter all 5 digits as required.
7. Now press and hold the
LEVEL
key. The entire Ident will
flash for a few seconds then the radio will beep as the new
Ident is stored.
Recalling SelCall Idents from memory
1. Briefly press the CALL button. is displayed along
with the last sent or received SelCall Ident.
2. Press the or keys to select the required Ident
memory in locations ‘C0’ to ‘C9’.
3. Press and hold the CALL button to send the Ident.
Changing your radio’s own SelCall Ident
1. Ensure your radio is in Numeric Mode (press then
as required until ‘NUMER’ is displayed).
2. Briefly press the CALL button. is displayed along
with the last sent or received SelCall Ident.
3. Press the key. ‘Id’ will be displayed along with
your radios own SelCall Ident.
4. Press and hold the
LEVEL
key until the radio beeps.
The right-hand digit of the SelCall Ident will flash.
5. Press the or keys to select the required
number in the flashing digit position.
6. Briefly press the
LEVEL
key again to select the next
digit position.
7. Repeat steps 5 and 6 to enter all 5 digits as required.
8. Now press and hold the
LEVEL
key. The entire Ident will
flash for a few seconds then the radio will beep as the
new Ident is stored.
LABELLING YOUR SELCALL IDENTS
You can label each SelCall Ident using a 5 character name
to make it easier to identify callers. If an incoming SelCall
matches one of those in your radio’s memory, the label can be
displayed instead of the SelCall Ident.
To select the ALPHA display mode
Briefly press the key followed by the key.
‘ALPHA’ or ‘NUMER’ will be displayed for 2 seconds on the
lower left of the display to indicate the selected mode.
TIP: The normal channel display may give no indication of
which display mode is selected. The selected more will only
become obvious when displaying SelCall Idents.
Entering and storing a SelCall Label
NOTE: You must first store the required Ident in memory (as
described above) before you can add an ALPHA label to it.
1. Briefly press the CALL button. will be displayed along
with the last sent or received SelCall Ident.
2. Press the or keys to select the required Ident
memory in locations ‘C0’ to ‘C9’.
3. Briefly press then to select the ALPHA mode.
ALPHA will be displayed briefly.
4. If the selected memory’s ALPHA label is empty, ‘- - - - -’
will be displayed, otherwise it will display the last ALPHA
label that was programmed into that memory.
5. Press and hold the
LEVEL
key until the radio beeps.
The left-hand position of the Alpha label will flash.
6. Press the or keys to select the required
character in the flashing position then briefly press the
LEVEL
key again to select the next position.
7. Repeat step 6 to enter up to 5 characters as required.
8. Now press and hold the
LEVEL
key. The entire Alpha label
will flash for a few seconds then the radio will beep as the
label is stored.
PAGE 16 INSTRUCTION MANUAL TX3350