User Manual

PAGE 6 INSTRUCTION MANUAL RC900 SERIES
If you wish to connect only two speakers, connect these to
the Rear speaker wires. The remaining speaker wires should
be insulated to ensure they cannot short circuit together or
to the vehicle’s 12 volt or negative electrical Bus. If using only
two speakers, adjust the Fader control to the rear speakers.
Antenna Connections
Connect an AM/FM antenna to the antenna socket
extending from the rear of the RC900. For information on a
suitable antenna, contact your nearest GME branch or
marine retailer.
iPod® Connectivity
The RC900 has a white lead which, when connected with
an LEO23 (optional 1.1 meter lead), enables an iPod® to
be connected directly to the stereo. Limited functions of the
iPod® can be accessed via the RC900, including the
selection of albums and songs. Access to displaying the
iPod® library on the RC900 is not available however the
iPod library and all functions can be viewed on the iPod.
Reset Button
When the installation is complete, press the Reset button
using a paper clip or similar object (see PRECAUTIONS on
page 5). This will ensure the RC900 is ready to operate for
the first time. If at any time the controls do not seem to
work (after replacing the vehicle’s battery for example),
press the Reset button to reset the microcomputer inside
the RC900.
FUSE REPLACEMENT
If any of the fuses blow, replace them with a standard
30 mm 3 AG type of the same rating. If the fuse blows a
second time contact your retailer.
The following fuse ratings are used:
- Yellow ‘Memory’ lead: 15 Amp.
- Red ‘Ignition Switch ACC’ lead: 0.5 Amp.
OPERATION
GENERAL FUNCTIONS
1
Power ON/OFF
To turn the RC900 ON, press the Power
Button. The unit
will resume the mode and settings that were selected when
last turned OFF.
To turn the RC900 OFF, press the Power button again.
Note that when the RC900 is turned OFF the clock is
displayed without the backlight.
Backlighting
Briefly press the Power button to change the brightness
of the back lighting. There are three levels of backlighting
available.
2 3
Audio Controls
The Volume, Bass, Treble, Balance and Fader controls are
selected electronically. The default setting is the
Volume Control.
To select an alternative control, press the SEL
3
button
until the desired function is displayed on the LCD. Each
press cycles to the next function in sequence. Adjust
the selected control function using the volume knob
2
.
FRONT AUDIO
OUT
BLACK
Lch WHITE Rch RED Lch WHITE Rch RED Ipod
GREY
WHITE
REAR AUDIO
OUT
REAR LEFT – GREEN/BLACK REAR LEFT + GREEN FRONT LEFT – WHITE/BLACK FRONT LEFT + WHITE
REAR RIGHT – PURPLE/BLACK
REAR RIGHT + PURPLE
FRONT RIGHT – GREY/BLACK
FRONT RIGHT + GREY