Manual

RC90 INSTRUCTION MANUAL PAGE 5
ELECTRICAL WIRING
DC Connections
Caution: The RC90 is designed for vehicles with a 12 Volt
negative ground electrical system only!
Refer to the wiring diagram:
1. Connect the Yellow wire directly to the positive terminal
ofthevehicle’sbattery,ortoapointthathas+12Volts
available at all times. This lead maintains the memories
within the RC90 and is the main power source for
the unit.
2. Connect the RED wiretothevehicle’s+12Vsupplyvia
the ignition switch. This lead enables the radio to be
switched ON and OFF. Alternatively, this wire can be
connecteddirectlytothebattery’spositiveterminaland
theRC90switchedONandOFFusingit’sowncontrols.
3.
Connect the BLACKwiretothebattery’snegative terminal
or to the common negative bus in the electrical system.
BLUE
AU TO ANTENNA
12 V+ OUT
Important:YourRC90isabletomaintainit’smemories
when it is switched off using the PWR button by drawing
power directly from your battery via the YELLOW ‘MEMORY
12V+’lead.Althoughthememorybackupcurrentisvery
small (about 10 mA) it may eventually discharge your
battery if left connected indefinitely. The time taken to
completely discharge your battery will vary depending on its
Amp-hour rating and battery condition.
Speaker Connections
When connecting the speakers, observe the correct polarity
as shown in the diagram below. Incorrect polarity will result in
a reduction of Bass response and stereo effect. The RC90 is a
four-speaker system that requires 2 separate wires for
each speaker.
Caution:
The use of speakers with an impedance of less
than 4 Ohms is not recommended as they will cause excessive
loadingoftheRC90’soutputcircuit and may result with the
radio overheating.
A range of GME speakers are available from your local
GME retailer.
REAR LEFT – GREEN/BLACK REAR LEFT + GREEN FRONT LEFT – WHITE/BLACK FRONT LEFT + WHITE
REAR RIGHT – PURPLE/BLACK
REAR RIGHT + PURPLE
FRONT RIGHT – GREY/BLAC K
FRONT RIGHT + GRE Y
Connect all four speakers as shown in the diagram above.
Adjust the Fader control for the required front/rear balance.
If you wish to connect only two speakers, connect these to
the Rear speaker wires. The remaining speaker wires should
be insulated to ensure they cannot short circuit together or
tothevehicle’s12VoltornegativeelectricalBus.Ifusing
only two speakers, adjust the Fader control to the
rear speakers.
Antenna Connections
Connect an AM/FM car radio antenna to the antenna
socket which extends from the rear of the RC90. For
information on a suitable antenna, contact your nearest
GME branch.
Reset Button
When the installation is complete, remove the front panel
and press the Reset button using a paper clip or similar
Antenna
Connector