MSDS

ManualsBrandsGlue Dots ManualsPaintAdvanced Strength Disposable Dispenser (125-Dots)

MATERIAL SAFETY DATA SHEET

Glue Dots International

GLUE DOTS BRAND ADHESIVE PRODUCTS

N117 W18711 Fulton Dr.

Germantown, WI 53022 ADHESIVES COVERED

Phone: (262) 814-8500 Advanced Strength Glue Dots® Disposable Dispenser

Emergency: (888) 688-7131 Advanced Strength Glue Dots® Refillable Dispenser

Advanced Strength Glue Dots® Refill Rolls

Preparation Date: 08/16/13

SECTION I. Product Identification

Product Information

Product Name: Advanced Strength Formula Glue Dots

Product Description (product use): Permanent Hot Melt Pressure Sensitive Adhesive

SECTION II. Composition/Information on Ingredients

This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety

and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the

Canadian Workplace Hazardous Materials Information System (WHMIS). Unlisted ingredients are not

“hazardous” per the OSHA standard and/or are not found on the WHMIS ingredient disclosure list.

Chemical/CAS # Percent OSHA PEL ACGIH TLV

See Section XVI. For additional information

SECTION III. Hazards Identification

Low hazard for usual industrial or commercial handling.

Human Health Hazards: None

Environmental Hazards: None

Other Hazards: Not classified

Special Notes: Some components are synthetic rubber compounds, which are essentially non-toxic.

This product does not contain regulated levels of NTP, IARC, ACGIH or OSHA listed carcinogens.

Existing Health Conditions Affected by Exposure: No known effect on other illnesses.

Summary of content (4 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET GLUE DOTS BRAND ADHESIVE PRODUCTS Glue Dots International N117 W18711 Fulton Dr. Germantown, WI 53022 Phone: (262) 814-8500 Emergency: (888) 688-7131 Preparation Date: ADHESIVES COVERED: Advanced Strength Glue Dots® Disposable Dispenser Advanced Strength Glue Dots® Refillable Dispenser Advanced Strength Glue Dots® Refill Rolls 08/16/13 SECTION I.
PAGE 2
SECTION IV. Skin: First Aid Measures Burns caused by molten product: Immerse contact area immediately in cold, clean water. Do not attempt to remove set product. Removal could result in severe tissue damage. Cover contact area with clean wet compresses and take subject to physician immediately. Room temperature skin contact. Wash with soap and water. Get medical attention if symptoms occur. NOTE TO PHYSICIAN: Material should not be forcibly pulled from the skin.
PAGE 3
SECTION VIII. Exposure Controls/Personal Protection The use of PPE is not necessary when product is used as directed. SECTION IX. Physical and Chemical Properties Physical state: Color: Odor: Odor Threshold: Weight per Gallon: Specific Gravity: pH: Boiling range: Freezing/Melting point: Vapor Pressure: Vapor Density: Evaporation Rate: Water/Oil partition Coefficient: VOC: SECTION X. Solid Clear to Off-white Neutral Not established 8.17 lbs .
PAGE 4
SECTION XV. Regulatory Information Federal Toxic Substances Control Act (TSCA) Section 8(b) - Inventory Status All components of this product are registered under the regulations of the Toxic Substances Control Act. SARA Title III. Section 313: This product does not contain regulated levels of any toxic chemical subject to the reporting requirements of section 313 of Title III.