User manual

GLP  German Light Products GmbH
impression X4 L User Manual Rev. B from software version: v045 9
3.2 Securing the Fixture
Regardless of the mounting method of the IMPRESSION X4 L you'll have to use a
stipulated safety wire. Attach the safety wire through one of the two holes provided
on the base of the fixture and connect it to the primary support structure. Pay
attention to a safe and proper fastening. The safety cable must comply with EN
60598-2-17 Section 17.6.6 and be capable of bearing a static suspended load that
is ten times the weight of the fixture and all installed accessories.
3.3 Connections
3.3.1 Power Supply
~100-240 Volt AC, 50-60 Hz, powerCON AC connector
Connected load 900 VA (W) <=> T10A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.
3.3.2 DMX
USITT DMX-512 Standard input/output in 5-pin connectors.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4&5 N.C.
The DMX- Addressing starts at the DMX- Address [001].