Owner manual
0020096883_02 - 08/10 - Glow-worm
- 29 -
MAINTENANCE
13 Re-check and restart
• Once the system is installed, check the operation of each
appliance.
• Start the system to ensure that any adjustments operate
correctly and check that the appliances operate safely.
• Reset the fault reports for all appliances. To do this, see
chapter "Activation > Components Info”.
• Check the water-tightness of the appliances and eliminate
any leaks.
• Check the entire control and safety system, settings and
operation.
• Start the "Self check" procedure to test the system
connections (refer to the chapter “Commissioning the control
unit > Self check”).
14 User information
At the end of the installation, the installer must:
- explain the operation of the appliances and its safety devices
to the user, if necessary provide a demonstration and answer
any questions;
- hand over to the user all the required documentation,
- ll in the documents where necessary;
- advise the user of the precautions necessary to prevent
damage to the system, appliances and the building;
- remind the user to service the appliances annually.
- The user shall not interfere with or adjust sealed
components.
- Any servicing must be carried out by a competent person
approved at the time by the Health and Safety Executive.
MAINTENANCE
15 Trouble-shooting
15.1 Fault diagnosis
The following checks should be performed before proceeding
onto specic diagnostics:
- Make sure that the electricity supply has not been interrupted
and that the appliance is connected correctly.
- Ensure that the isolating valves are open.
- Check that all external controls are connected correctly.
15.2 Fault codes
i
The faults described in this chapter should be
carried out by a qualied engineer and if needed by
the After Sales Service.