Owner manual

0020096883_02 - 08/10 - Glow-worm
- 26 -
INSTALLATION
"Heat pump" ow / pressure curve
60
50
40
30
20
10
0
300 600 900 1200
B
1 2
Key
1 With water 20°C
2 With glycol solution (mix at 30%) at 20°C
A Available pressure (kPa)
B Flow within the circuit (l/h)
12.9 Status reports
This menu enables real-time access to:
- the status of the appliances responding to a request (ON/
OFF)
- the information available from the appliances (temperature,
pressure, ow, ...),
- register of last 5 faults recorded for each appliance (failure
code and description)
i
Refer to the "Troubleshooting> fault codes" chapter for
a description of the fault code displayed on the screen.
- to reset the report for each appliance.
• Using the buttons ,
select Status reports on the screen.
• Press the button
to conrm.
12.9.1 Information on the boiler
• Using the buttons ,
select Boiler on the screen.
• Press the button
to conrm.
This screen indicates whether the boiler
responds to a request (ON or OFF).
• Press the button
to consult a
fault report.
• To reset the fault report, press
and conrm with the button
.
12.9.2 Information on the heat pump
i
Refer to "Troubleshooting> Heat pump status" for
a description of the status report displayed on the
screen.
• Using the buttons ,
select Heat pump on the screen.
• Press the button
to conrm.
This screen indicates:
- whether the heat pump responds to a
request (ON or OFF)
- the heat pump status report (ON or
OFF).
• To access the information relative to
the components, press
and conrm with the button
.
• Press the button
to consult a
fault report.
• To reset the fault report press
and conrm with the button
.