Manual

0020096321_00 - 07/10 - Glow-worm
- 20 -
INSTALLATION
9 Activating the room thermostat
1
2
3
Key
1 Battery cover
2 Protective cover
3 Room thermostat
• Remove the protective cover (2) located in the battery
compartment following the order (A) to (C).
• The main screen of the room thermostat is displayed.
10 Activating the control unit
a
Ensure that the heat pump and heating circuits
have been fi lled.
e
Ensure that all the electrical connections have
been made.
• Switch ON the circuit breaker which is located on the
electrical panel and connected to the control unit.
1
Key
1 Switch On (I) / Off (O)
• Turn on the control unit (1) with the switch (2) in position (I).
When connected for the fi rst time, the installation menu is
displayed.
• Use the buttons to select
a language.
• Press the button
to confi rm.
• Enter the installer access code 96
with the buttons .
• Press the button
to confi rm.
10.1 Confi guring the installation
• Follow and confi rm the steps
prompted by the initial installation
aid.
• Press the button
to confi rm.
Your system corresponds to diagram
number "4" in the control unit.
• Choose diagram number "4" with the
buttons
.
• Press the button
to confi rm.
Multizone kit' refers to zone valves for
more than one heating zone.
• If so, choose "YES".
• Use the button
to confi rm and
follow the control unit instructions.
• If this is not the case and the
installation has only one zone, choose
"NO" with the buttons
.
• Press the button
to confi rm.