Manual

3. Pull back the slide with free hand, and allow it to spring forwards into the final position. The
trigger finger of the shooting hand remains outside the trigger guard. The weapon is now
secured and ready to fire.
4. After the last round has been fired, the slide remains open. Remove the empty magazine from
the weapon by pushing the magazine catch (19). Insert a new magazine and then either push
the slide stop lever (27) downwards (see photo), or pull the slide slightly backwards and allow it
to spring forwards. The weapon is now again secured and ready to fire.
UNLOADING
1. Remove the magazine (see photo).
2. Pull slide (1) back to eject the round which is in the barrel (2).
3. Check to ensure that there is no round in the barrel
4. Allow the slide to spring forwards and pull the trigger into the full pulled position.
DISMANTLING AND REASSEMBLING
1. For normal cleaning, it is sufficient to dismantle the weapon into its MAIN COMPONENT
PARTS
– slide (1)
– barrel (2)
– recoil spring assembly (3)
– receiver (17)
– magazine
2. For maintaining and cleaning the weapon, it is recommended that the cleaning equipment
provided as part of the accessories be used, together with the cleaning wadding and special
gun greases and oils available from specialist dealers.
3. The GLOCK pistols are stripped into the main component parts in the following order:
– removing the magazine
– checking safety (ensuring there is no round in the barrel)
– pulling trigger right back
– removing barrel from slide. Before the slide and the receiver are dismantled any further,
attention is drawn to the safety and guarantee conditions.