User's Manual
GLMU20A01 User Manual
Copyright © 2020 uCloudlink All Rights Reserved
GLMU20A01 说明书
Copyright © 2020 uCloudlink All Rights Reserved
1. Signal LED Indicator 2. Wi-Fi LED Indicator
3. Battery LED Indicator 4. Power button
5. SIM Slot
6. Type-C(Input)
7. Reset button
1. 4G 2. WIFI
3. 4.
5. SIM
6. Type-C
7.
1. Type-C charging
Function Introduction
Local SIM
Technical Specification:
2. Lightning charging
3. Micro charging
Product Overview
Product Overview
1. Power on: Press power button for 3 seconds.
2. Power off: Press power button for 5 seconds.
3. Reset: Press power button for 14 seconds.
4. Restore factory settings：Press reset button for 5
seconds.
5. Battery capacity and signal strength: Press the power
button, the battery capacity will be shown in the first 3
seconds, then the signal strength will be shown afterwards.
LED Indicator Type Status Remarks
Wi-Fi LED
On Ready for internet connection
Off No internet connection
Flashing Service connecting
4G LED
RED The signal is bad
Yellow The signal is normal
Green The signal is Good
Red flashing Connecting error
Battery
On
The battery capacity is shown by
strength LED indicator
Flashing Charging
1.
Local SIM is supported by GLMU20A01, Only
insert Nano-SIM card (small card).
2. Use a needle to pull out the SIM
cards as shown in the picture below.
Please contact customer service if
any issue encountered
3.
GLMU20A01 device does not
support SIM cards with PIN code,
if you want to use this type of SIM
cards, please unlock the PIN code
first.
3.
GLMU20A01 device does not support SIM
cards with PIN code, if you want to
use this type of SIM cards, please
unlock the PIN code first..
Function Introduction
Quick Start Guide
Brand：GlocalMe Model No.: GLMU20A01
Box content: Device, User manual, Type-C cable, SIM
removal too
• Size: 143*69*16mm
LTE FDD：
• LTE TDD：
• WCDMA：
• GSM：
B1/2/3/4/5/7/8/9/12/13/
18/19/20/26/28/66
B34/38/39/40/41(194M)
B1/2/5/6/8/9/19
850/900/1800/1900
• Max upload speed: 50Mbps
• Max download speed: 150Mbps
• Wi-Fi: IEEE802. 11b/g/n
• USB port: Type-C (input)
• Battery Capacity: 7000mAh
• Power Input: DC 5V 2A
• Power output 5V 2A (TYPE-C,Micro-USB，
lighting）
Note:
Listed wireless data transfer rates are the theoretoical
maximum. The actual data transfer rate may vary
depending on the network environment and carrier’s
coverage.
1. Register an Account：Scan the QR
code below to download the GlocalMe
App. You can register for an account
after installation.
2. Activate Device: Use the GlocalMe
app to scan the QR code on the back
panel of the device.
3. Purchase Package: Purchase
package or top up through the GlocalMe
app.
4. Power On: Press power button for 3
seconds.
5. Connect to GlocalMe: When the Wi-Fi LED indicator
“ ” is staying on, turn on Wi-Fi on your cell phone,
select GlocalMe Wi-Fi, enter the password to connect
to the internet. (Wi-Fi name and password can be seen
on the back panel. as shown below)
6. Device Management: Enter “192.168.43.1” in the
address bar of web browser, and enter the username and
password to login.(The initial username and password
are admin/admin).
7. Use the device to charge the mobile phone and other
devices: insert the charging head directly into the mobile
phone and other devices, and press the power key once
to activate the discharge. (if the device is idle for 5
minutes without external equipment, it will start to
hibernate, press the power key to activate).
Warning Warning
Specific Absorption Rate (SAR) refers to the rate at
which the body absorbs RF energy. The SAR limit is 1.6
watts per kilogram in countries that set the limit averaged
over 1 gram of tissue and 2.0 watts per kilogram in
countries that set the limit averaged over 10 grams of
tissue. During testing, the device are set to their highest
transmission levels in all tested frequency bands,
although the SAR is determined at the highest certified
power level, the actual SAR level of the device while
operating can be well below the maximum value.
Type-C
Lightning
Micro
1
2
3
Type-C
Lightning
Micro
1
2
3
The device complies with RF specifications and when
used with an accessory that contains no metal and that
positions the device a minimum of 0.5 cm from the body.
The SAR limit adopted is 2.0W/kg averaged over 10
grams of tissue. The highest SAR value reported for the
device when properly worn on the body complies with the
limit.
EU Regulatory conformance
For body worn operation, the device complies with FCC
RF exposure guidelines and when used with an
accessory that contains no metal and that positions the
device a minimum of 1.0 cm from the body.
The SAR limit adopted by the FCC is 1.6W/kg averaged
over 1 gram of tissue. The highest SAR value reported for
the device when properly worn on the body complies with
the limit.
FCC Regulatory conformance
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause.
Undesired operation. Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and complies with
the limits for a class B digital device, pursuantto part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur during installation. If the device does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is suggested to try to correct the interfernce by the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the distsnce between the equipment and
receiver
--Connect the equipment to an outlet on different circuit to
the receiver
--Consult the manufacturer or an experienced radio/TV
technician for help.
Information on the disposal and recycling of the devices.
This symbol (with or without a solid bar) on the device,
batteries (if included), and/or the packaging, indicates that
the device and its electrical accessories (for example, a
headset,adapter,or cable) and batteries should not be
disposed of as household garbage. These items should
not be disposed of as unsorted municipal wasted and
should be taken to a certified collection point for recycling
or proper disposal. For detailed information about device
or battery recycling, contact your local city office,
housedhold waste disposal service, or retail store.
Disposal of the device and batteries ( if included) is
subject to WEEE. Directive recast (Directive 2012/19/EU)
and battery dirctive (Directive 2006/66/ec). The purpose of
separating WEEE and batteries from other waste is to
minimize the potential environmental impacts and human
health risk of any hazardous subsatances that may be
present.
EC ERP
Ocean Trading GmbH
Anhalter Str.10, 10963, Berlin, Germany
info@oceantrading.de
Copyright © 2020 uCloudlink All Rights Reserved
Hong Kong uCloudlink Network Technology Limited
E-mail: service@ucloudlink.com
Hotline: +852 8191 2660 or +86 400 699 1314 （China）
Facebook: GlocalMe
Instagram: @GlocalMeMoments
Twitter: @GlocalMeMoments
YouTube: GlocalMe
Address: SUITE 603, 6/F, LAWS COMMERCIAL PLAZA, 788
CHEUNG SHA WAN ROAD, KOWLOON, HONG KONG
GlocalMe WeChat platformfacebook.com/GlocalMe
This product and related system are protected by one or more
of uCloudlink’s patents, details please refer to
https://www.ucloudlink.com/patents
Ver 1.0
6
7
6
7
1. Type-C 2. Lightning
3.
指示灯类型 状态 说明
WIFI联网指示灯
常亮 可以上网
灭 不可以上网，等待灯亮
闪烁 正在联网中
信号指示灯
红灯 信号等级0-1
黄灯 信号等级2-3
绿灯 信号等级4
红灯闪烁 联网异常
电量指示灯 亮
强度指示灯（4）显示的为电池电
量
持续闪烁 充电中
GLMU20A01
进出口管制
操作环境
儿童健康
交通安全
医疗设备
无承担说明
电磁辐射比吸收率（SAR）
维护和保养
产品中有毒有害物质或元素的名称及元素
部件名称
有毒有害物质或元素
终端设备
此产品以及相关系统受优克联专利技术保护，详情请查阅
https://www.ucloudlink.com/patents