Datasheet

GlobTek, Inc.
www.globtek.com
186 Veterans Drive,
Northvale, NJ 07647
Tel. [phone]
Fax [phone]
Drawing Title:GT-41080-1817.9-5.9, ITE Power Supply, Efficiency Level: V, Case Color/Style: GlobTek Black,
Wall Plug-in, Regulated Switchmode AC-DC, Input Rating: 100-240V~, 50-60 Hz, Interchangeable Blades
http://en.globtek.com/interchangeable-blades.php, Output Rating: 18W, 12V@1.5A, Output Configuration: 1830
mm, 20/1C + Shield Cond, UL 1185, Female Barrel 5.5 * 2.5 * 11mm No internal Spring Clip nor Locking Notch
or Equal, Ferrite: None, GlobTek Black, GT Cord # C0284, Pin Out: Center Positive (+V), Blades/Input Cord:
Q-Series Europe, Approvals: C-Tick, CB, CCC, China RoHS, cULus, Double Insulation, EC, GOST-R, IP52,
IRAM, Korea, Korea (12V Only), Level V, LPS, NEMKO, NrCan, PSE, RoHS 2, Ukraine, VCCI, WEEE
Model No.GT-41080-1817.9-5.9
Part No.WR9QE1500LCPNEU(RVB) RevA
PROPRIETARY INFORMATION
PROPRIETARY OF GLOBTEK, INC. ANY REPRODUCTION, DISCLOSURE OR USE OF THIS DRAWING, IN WHOLE OR IN PART, IS HEREBY PROHIBITED EXCEPT AS SPECIFIED IN
WRITING BY GLOBTEK, INC.
rmünt /07/15/2014 11:20:13 AM
Page 2 of 11
POWER SUPPLY INFORMATION
TYPE: Wall Plug-in
TECHNOLOGY: Regulated Switchmode AC-DC
CASE COLOR: GlobTek Black
NAMEPLATE RATED
INPUT:
100-240V~, 50-60 Hz, 0.6A
INPUT CONFIG: Interchangeable Blades
WATTS: 18.0
VOLTS OUT: 12
CURRENT OUT (Amps): 1.5
BLADE/CORD INCLUDED: Q-EU:Q-Series Europe
BLADE/CORD INSTALLED: Q-EU:Q-Series Europe
EFFICIENCY LEVEL: V
OUTPUT
CONFIGURATION
1830 mm, 20/1C + Shield Cond, UL 1185, Female Barrel 5.5 * 2.5 * 11mm No internal Spring Clip nor Locking Notch or
Equal, Ferrite: None, GlobTek Black, GT Cord # C0284
CONNECTOR PIN OUT: Center Positive (+V)
LABEL SPECS: Standard GT,L-1186
PACK SPEC: Standard WPI Q-EU installed, Individually Box
NOTES / DEVIATIONS:
DIMENSIONS ARE IN MM UNLESS SPECIFIED OTHERWISE.
ELECTRICAL SPECIFICATIONS
A) ELECTRICAL SPECIFICATIONS:
01. Input Voltage: Specified 90-264 Vac, Nameplate rated: 100-240Vac
02. Input Frequency: Specified 47-63 Hz, Nameplate rated 50-60Hz
03. Line Voltage Regulation: +/- 1% typical measured at the output connector
04. Output Ripple (Vp-p): +/-1% or 150 mV whichever is greater, measured at 20 MHz bandwidth with 0.1 uf ceramic capacitor in parallel
with 10 uf electrolytic capacitor connected at the end of the output connector at nominal line
05. Turn-ON/OFF Overshoot: 5% maximum, 1 mS typical recovery time for 25% to 50% step load
06. Turn-ON Delay: 1 second typical
07. Hold-Up Time: 8 mS typical @ nominal input voltage and full load
08. Inrush Current: 30A typical at 115VAC input and 60A typical at 230 VAC input
09. Switching Frequency: 65 KHz typical
B) PROTECTION
01. Over-Voltage: Protected Zener clamp across the output
02. Short Circuit: Protected unit will auto recover upon removal of fault
03. Input Protection: Input line fusing
C) SAFETY
01. Dielectric Withstand Voltage: 4242Vdc from primary to secondary
02. Touch Current: <0.25mA @ 240Vac input voltage
03. ROHS 2: Complies with EU 2011/65/EU and China SJ/T 11363-2006
D) OTHER:
01. MTBF: 200,000 Hours @ 25°C ambient temperature
02. Operating Temperature: 0°C to 40°C ambient temperature
03. Humidity: 0% to 90% relative humidity
04. Storage Temperature: -10°C to 80°C
05. Cooling: Convection
E) ENCLOSURE
01. Housing: High impact plastic, 94V0 polycarbonate, non-vented