User's Manual

2. Connect the receiver that comes with the product to a USB port on the computer,
the LED on the receiver lights to indicate that the PnP connection has been
successful.
3. Setting the identification code:
3.1 Press the "Lock" key on the receiver once, as indicated in fig. 2, the LED lamp
goes off .
3.2 Press the "ID" key on the presenter once, as indicated in fig. 1, the LED will
light up to indicate that the setup has been completed, and the presenter is now
working.
3.3 This product features a total of 1024 sets and 8 channels of identification
codes to avoid interference. The setup mechanism automatically generates a
set and channel of identification code every time you press the “ID” key, the
presenter can only be used after the setup has completed.
Fig(2)
4. Power switch ON/OFF：
If you have purchased the presenter, an on/off power switch is provided on the bottom
of it, as shown in fig 3, please switch it off to save battery usage when carrying the
presenter as you travel. The presenter becomes ready once the switch is turned to "on"
and no identification code setting up will be necessary.
Fig(3)
Power switch
LED
Lock key