User's Manual

Installation method
Before using it, please press Connect button for one
second to turn on the power. Press Scrolling button to
activate the mouse cursor if it has not movement.
1. Plug the receiver into an available USB port on the
computer.
2. Press the Setup button on the receiver to turn off the
LED light. (Fig.2)
3. Hold the mouse close to the receiver. Press the
Connect button of the mouse (Fig. 1) till the
receiver’s LED light blinks indicating that the set-up
has been completed.
Note: For initial use, please recharge at least 4 hours.
If it has any lag, kindly check battery power.
- 2 -
LED light
Setup button
Fig. 2
Fig. 1
Connect button