User's Manual

6
Targus Wireless Keypad & Mouse Set
3 Turn on the keypad by sliding the Power switch on the
right side of the keypad to the “on” position.
Connecting the Receiver
To connect the receiver:
1 Plug the USB receiver into an available USB port on
your computer.
2 Follow any on-screen instructions to complete the
default driver installation.
The “Lock LED” light turns on.
You are now ready to set the identification code to
establish a communication link with the receiver.
Setting the Identification Code
After your computer detects the USB receiver and the
driver software is installed, you must set the ID code
between the receiver and the mouse as well as between
the receiver and the keypad BEFORE you can use them.
To do this, do the following:
NOTE: M
AKE SURE THAT YOUR COMPUTER IS TURNED ON AND HAS
DETECTED
THE USB RECEIVER BEFORE YOU SET THE ID CODE.
LED
Setup key
PAKP003U-10.book Page 6 Saturday, November 5, 2005 10:55 PM