Installation Guide

Step 10
Step 10A
Fit the front fascia panel to the FRONT top rail by
sliding the bottom back edge of the fascia panel
into the flange at the top of the front top rail.
See Diagram 9.
IMPORTANT: If you are constructing an
8' wide shed go directly to Step 10A now.
ATTACHING THE FRONT FASCIA PANEL
5' & 6' wide sheds
FLANGE
ON FRONT
TOP RAIL
BOTTOM
BACK EDGE
FRONT
FASCIA
PANEL
FRONT
TOP
RAIL
SCREW
BACK
FRONT FASCIA PANEL
(INSIDE VIEW)
TOP RAIL
Diagram 10
FRONT FASCIA PANEL
(RIGHT SIDE VIEW)
FLANGE
ON FRONT
TOP RAIL
BOTTOM
BACK EDGE
FRONT
FASCIA
PANEL
FRONT
TOP
RAIL
FRONT FASCIA PANEL
(RIGHT SIDE VIEW)
Diagram 11
Step 11
Fit the left and right side gables to the side
top-wall rails by sliding the inside bottom edge
of the gable into the flange at the top of the
side top-wall rail and secure using screws.
See Diagram 12.
ATTACHING THE 2 SIDE GABLES
FRONT
FRONT
FASCIA
PANEL
FLANGE AT TOP OF
FRONT TOP RAIL
Diagram 9
Fit the left and right front fascia panels to the
FRONT top rail by sliding the bottom back edge
of one panel into the flange at the top of the front
top rail and aligning it to the left side of the top rail.
See Diagram 11.
Then repeat for the other panel, overlapping the
holes at the centre. See Diagram 11.
8' wide shed
IMPORTANT:
Ensure LEFT front fascia panel is
positioned at LEFT side (when viewing
from front of shed) and RIGHT front
fascia panel is positioned at RIGHT side.
The left and right panels can be identified
by having no hole at the outside edge of
the bottom flange. See Diagram 11.
Secure using eight screws into the top beam and
four nuts and bolts in the centre overlapping holes
of the front fascia panels. See Diagram 11.
SCREW
BACK
TOP RAIL
BOTTOM
FLANGE
FRONT FASCIA PANELS
(INSIDE VIEW)
NUT &
BOLT
RIGHT
FRONT FASCIA PANEL
WITH NO HOLE NEAR
EDGE OF BOTTOM FLANGE
LEFT
FRONT FASCIA PANEL
WITH NO HOLE NEAR
EDGE OF BOTTOM FLANGE
OVERLAPPING
HOLES
Diagram 12
LEFT SIDE
GABLE
FRONT FASCIA PANEL
NUT &
BOLT
NUT &
BOLT
RIGHT SIDE
TOP-WALL RAIL
RIGHT SIDE
GABLE
FRONT
FLANGE
RIGHT SIDE
TOP-WALL
RAIL
INSIDE
BOTTOM
EDGE
RIGHT
SIDE
GABLE
(FRONT
EDGE)
GABLE - RIGHT SIDE
(FRONT VIEW)
SCREW
SCREW
15
Secure to the front fascia panel using
four nuts and bolts as shown.
NOTE FOR 3' DEEP SHEDS ONLY:
Only three nuts and bolts are required to
join the gables to the front fascia panel in
the corresponding far right and left corners.
See Diagram 12.
Secure using six screws.
See Diagram 10.
E N G L I S H
© Globel Industries Pty Ltd
GI00045 September 30 2015