Installation Guide

Pre-Assembly
GABLES
Front and back gables assembly:
Attach the gables to a top rail
by sliding the gable bottom
flange under the protruding
flange of the top rail.
Secure using three
screws per gable,
along the top edge
of the rail as shown
in Diagram 1.
Note:
Diagram shown is 6' wide shed.
8' wide shed: use four screws per gable.
10' wide shed: use five screws per gable.
(i)
(You will be making two gable assemblies)
(ii)
(iii) Repeat for other top rail and gables.
Join the two gables together by
inserting a nut and bolt in each of
the BOTTOM two holes in the
side flanges as shown in Diagram 2.
Diagram 2
SIDE
FLANGE
BOTTOM
2 HOLES
LEAVE
TOP HOLE
EMPTY
ON ALL
MODELS
6' Wide Shed
LEAVE
TOP HOLE
EMPTY
LEAVE
BOTTOM HOLE
EMPTY
LEAVE
TOP HOLE
EMPTY
10' Wide Shed8' Wide Shed
Diagram 1
GABLE
GABLE
FLANGE ON
TOP RAIL
FLANGE ON
GABLE
TOP
RAIL
6' Wide Shed
8
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H