Installation Guide

Fit the roof corner caps to the
four outside corners of the shed
and secure with nut and bolt
as shown in Diagram 27.
Step 26
Fit the gable name plates
to the top centre outside pitch of
the front and back gables.
Secure using two nuts and bolts.
Then bend the two bottom tabs
up and underneath the lip of
the roof starter as shown in
Diagram 25.
NOTE:
Name plate fits OVER the front
top edge of the roof starter.
Step 24
Diagram 25
GABLE
NAME PLATE
LIP OF
ROOF
STARTER
BOTTOM
TAB
BEND
BOTTOM
TAB
UP
ALL SIZE SHEDS:
Step 25
Diagram 27
FRONT
ROOF
CORNER
CAP
BACK
NUTS AND BOLTS
IN THE 3 INNER HOLES
ONLY
ROOF TRIM
TOP FACE
OF ROOF
SHEET
FRONT
Diagram 26
ROOF TRIM
FIXED IN POSITION
UNDERSIDE
OF TOP
FACE OF
DOOR TRIM
SEATED ON
TOP FACE
OF ROOF
SHEETS
Attach the side roof trims to the
left and right side edges
of the roof sheets as
shown in Diagram 26,
by sliding the
underside of the
roof trim under
the edge of the
roof sheets, so the
underside of the
top face of the roof
trim is seated onto
the top face of the
roof sheets.
Secure using nuts
and bolts
ONLY IN HOLES
AS SHOWN.
NOTE:
Roof corner cap fits OVER roof trim.
Washers are not required for this step.
30
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H