Installation Guide

Step 23A
Refer to Diagram 24A.
Fit the SHORT roof cap to the top of
the standard
roof cap already secured to the back of the shed
and line up the holes.
NOTE: At this point, using two nuts and bolts ONLY,
secure the short roof cap to the back standard roof cap
in the aligning two holes ONLY.
Then refer to Step 23 (on previous page) for fixing the
remaining standard roof cap at the front of the shed.
6' DEEP SHED:
CONFIGURATION OF ROOF CAPS
FOR 8' DEEP SHED
SHORT
ROOF CAP
CONFIGURATION OF ROOF CAPS
FOR 6' DEEP SHED
BACK
FRONT
Diagram 24A
STANDARD
ROOF CAP
SECURED TO SHED
(AT FRONT)
STANDARD
ROOF CAP
SECURED TO SHED
(AT BACK)
4 NUTS
& BOLTS
FITTING ADDITIONAL SHORT ROOF CAPS -
FITTING SHORT ROOF CAPS
Refer to Diagram 24B.
Fit one of the three short roof caps to the top of the
standard roof cap already secured to the BACK of the
shed, and line up holes. Secure with two nuts and bolts
at the back of the short roof cap. Then fit the remaining
two short roof caps, working from the back to the front.
NOTE: At this point, using two nuts and
bolts ONLY, secure the short roof cap to the
back standard roof cap in the aligning two holes ONLY.
Fit subsequent short roof caps in sequence to the
remaining roof sheets on right side of shed.
Fit remaining standard roof cap to front of shed as per
Step 23 (on previous page).
8' DEEP SHED:
Depending on the DEPTH of your shed (measurement front to back), you will need to use the
STANDARD roof caps and additional SHORT roof caps supplied. The SHORT roof caps are
to be positioned between the two STANDARD roof caps.
This page shows the configuration and numerical order for installation of additional SHORT roof caps
for 6' DEEP and 8' DEEP sheds. If you are installing additional SHORT roof caps, fit them as you
attach the subsequent roof sheets
and finish with a STANDARD roof cap at the front.
Ensure ALL holes in the SHORT roof caps are filled.
, using the same procedure as shown in
these diagrams
Steps 19 to 21 MUST be completed before fitting SHORT
roof caps. A SHORT roof cap MUST be fitted in
correspondence with each subsequent roof sheet
at the right side of the shed.
If this procedure is not followed you will not be able
to reach to fit and secure the short roof cap at a later point.
BACK
FRONT
1
Diagram 24B
STANDARD
ROOF CAP
SECURED TO SHED
(AT BACK)
SHORT
ROOF CAP
8 NUTS
& BOLTS
STANDARD
ROOF CAP
SECURED TO SHED
(AT FRONT)
3
2
IMPORTANT:
IMPORTANT: 6' wide & 8' wide sheds:
HINT:
29
For sheds more than 5' DEEP:
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H