Installation Guide

Step 20
Repeat the procedure, and fit and
secure the back and front roof sheets
on the left side of the shed in the
order shown in Diagram 21.
NOTES:
First (back) sheet
overlaps back roof starter.
Second sheet overlaps first sheet
and front edge of roof starter.
Step 19
Fit one FULL roof sheet to the back,
right side, ensuring it is the correct
way up, and the back edge overlaps
the roof starter.
Line up the holes in
the roof sheet with the
holes in the top of the
roof beam.
Secure using eight screws
as shown in Diagram 20.
8' & 10' WIDE SHEDS ONLY:
8 SCREWS
BACK
FULL ROOF
SHEET
EDGE OF
FULL
ROOF SHEET
TO
OVERLAP
EDGE OF
ROOF
STARTER
Diagram 20
Secure roof sheet to roof starter with additional nuts and bolts. See Diagrams 20A and 20B.
Roof sheets for 10' wide shed ONLY:
Also secure to mid roof beam using
screws. See Diagram 20B.
Follow this procedure for ALL
subsequent roof sheets.
NOTE - HALF SHEETS:
Diagram shows FULL roof sheets.
Half roof sheets have less holes.
Half sheets for 10' wide sheds only
use two screws into mid roof beam.
In addition to screws in roof sheet, as per Step 19:
8' Wide Shed
1 x nut and bolt
into previous
roof sheet or
roof starter.
Diagram 20A
PREVIOUS
ROOF SHEET
OR ROOF STARTER
NUT &
BOLT
ROOF SHEET
10' Wide Shed
2 x nuts and bolts
into previous
roof sheet or
roof starter.
4 x screws into
mid roof beam.
Diagram 20B
PREVIOUS
ROOF SHEET
OR ROOF STARTER
ROOF SHEET
SCREW
INTO
MID ROOF BEAM
NUT &
BOLT
2
1
Diagram 21
BACK
BACK EDGE
OVERLAPS
FIRST SHEET
FRONT EDGE
OVERLAPS
ROOF STARTER
27
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H