Installation Guide

HALF HALFHALF
FULL
Step 18
Repeat steps 16 & 17
to attach and secure the
remaining three roof starters
to the top edges of the
gable assemblies, as shown
in Diagram 19.
IMPORTANT:
The rows of holes in the TOP of
ALL roof sheets are closer together
than the bottom rows.
Hole configurations are different for
6', 8' & 10' wide sheds. This Diagram
shows roof sheets for 6' wide sheds.
Roof sheets for 8' & 10' wide sheds
are referred to later in this manual.
ROOF SHEETS & ROOF CAPS
ROOF CAPS
ROOF SHEETS
TOP:
ROWS OF HOLES
CLOSER
TOGETHER
BOTTOM:
ROWS OF
HOLES
HALF
ROOF SHEET
FULL
ROOF SHEET
IMPORTANT:
Steps 19 - 23 show the installation procedure and sequence for roof sheets and roof caps for a 6' wide x 5' deep shed.
If you are constructing an 8' wide x 6' deep or 10' wide x 8' deep shed: Study the installation NUMBER sequence
diagram below, then follow Steps 19 - 23A, for procedure, and fit the roof sheets and roof caps in the respective order.
10' WIDE x 8' DEEP SHED
6 x full roof sheets, 2 x half roof sheets,
2 x standard roof caps, 3 x short roof caps
8' WIDE x 6' DEEP SHED
4 x full roof sheets, 2 x half roof sheets,
2 x standard roof caps, 1 x short roof cap
LEFT SIDE RIGHT SIDE
FULLFULL
FULLFULL
HALF
STANDARD
STANDARD
SHORT
ROOF SHEETS ROOF SHEETS
ROOF
CAPS
1
6
7
9
8
53
2
4
INSTALLATION NUMBER SEQUENCES:
LEFT SIDE RIGHT SIDE
STANDARD
STANDARD
SHORT
SHORT
SHORT
ROOF SHEETS ROOF SHEETS
ROOF
CAPS
1
7
11
10
FULL
12
8
FULL
9
FULL
4
FULL
3
2
FULL
5
6
13
STANDARD ROOF CAP SHORT ROOF CAP
FRONT
FRONT
Depth of sheds will vary - Count the number of roof sheets in the carton to determine your specific installation arrangement.
If you are constructing a shed that is a different depth to the ones shown, use the instructions and
installation number sequence diagram as a guide only.
ALL 4
ROOF STARTERS
IN PLACE
BACK
Diagram 19
26
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H