Installation Guide

25
IMPORTANT:
For the roof starters, sheeting and caps,
every screw and bolt must have a washer.
SCREW BOLT
WASHER WASHER
Fit one of the roof starters to the top edge
of the right side, BACK gable assembly and
secure to the roof beam using two screws
in the positions shown. See Diagram 17.
Step 16
ROOF STARTERS, SHEETING & CAPS
ROOF STARTERS
Step 17
Secure the roof starter to the
gable assembly using
five nuts and bolts with washers,
in the holes along the vertical
edge of the roof trim.
See Diagram 18.
NOTE 1:
Using a nut and bolt, fill the
spare hole near the top of the
roof starter as shown in
Diagram 18.
Diagram 17
ROOF
STARTER
ROOF
BEAM
ROOF
BEAM
ROOF
STARTER
TOP
EDGE OF
GABLE
ASSEMBLY
TOP EDGE
OF GABLE
ASSEMBLY
SCREWS IN
THESE 2 HOLES
BACK
5 NUTS
& BOLTS
IN EDGE OF
ROOF TRIM
BACK
HOLE IN
VERTICAL
EDGE OF
ROOF TRIM
ROOF
STARTER
Diagram 18
6' Wide Shed
8' Wide Shed:
Use seven nuts & bolts
FIXING ROOF STARTERS
10' Wide Shed:
Use nine nuts & bolts
NOTE:
(NOTE 1)
NUT & BOLT
(FILLS SPARE
HOLE)
(NOTE 2)
SCREW
INTO
TOP-WALL
RAIL
(NOTE 3)
10' WIDE
SHEDS ONLY:
SCREW IN
CENTRE HOLE OF
ROOF STARTER
INTO MID ROOF
BEAM
Roof Starter
8' Wide Shed
1 x EXTRA HOLE
Roof Starter
10' Wide Shed
3 x EXTRA HOLES
NOTE 2: Secure a screw
through the hole near the
bottom of the roof starter and
into the top edge of the top-wall rail,
as shown in Diagram 18.
IMPORTANT:
NUTS AND BOLTS MUST BE INSERTED AS SHOWN
IMPORTANT:
Roof starters for 6' wide sheds are
shown throughout these assembly
instructions.
Roof starters for 8' wide and 10' wide
sheds have extra holes as shown here.
NOTE 3 - 10' wide sheds ONLY:
Secure a screw through the hole at the centre of the
roof starter and into the mid roof beam, as shown in
Diagram 18.
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H