Installation Guide

FRONT
BASE RAIL
ENTRY/EXIT
RAMP
Diagram 16
FRONT
LEFT
DOOR
JAMB
RIGHT
DOOR
JAMB
Diagram 15A
LEAVE
THESE
HOLES
EMPTY
LEFT
CORNER
PANEL
Step 14
Step 15
Attach the entry/exit ramp to the front base rail,
and secure using six screws. See Diagram 16.
24
WALL SHEETS - FRONT
IMPORTANT:
go directly to Step 14A now.
If you are assembling a 6' wide shed,
Fit one of the front wall sheets to the front LEFT corner
panel by slightly prising up the right edge of the corner
panel and sliding the wall sheet under, as shown in
Step 11A, Diagram 12A, Page 21.
Secure using screws and follow the numerical order
shown in Diagram 11A, page 20.
Repeat procedure for attaching remaining wall sheet
at RIGHT side. See Diagram 15.
DOOR JAMBS
Attach one of the door jambs to the front
LEFT corner panel
the LEFT front sheet (for 8' wide & 10' wide sheds)
by slightly prising up the right edge of the
corner panel or front wall sheet and sliding
the door jamb under, as shown in the
diagram in Step 11A. NOTE: Door jambs for
8' and 10' wide sheds are different in shape
to those shown in Diagram 15A.
(for 6' wide sheds) or
Step 14A
FOR 6' WIDE SHED:
Secure with three screws in the bottom
of the door jamb, two screws (ONLY) in
the top of the door jamb and three screws
in the front mid-rail. See Diagram 15A.
FOR 8' WIDE & 10' WIDE SHEDS:
Secure with two screws in the bottom of
the door jamb, one screw (ONLY) in the
top of the door jamb and two screws
in the front mid-rail.
IMPORTANT - ALL Shed Sizes:
Leave top inside hole empty, as shown in
Diagram 15A.
Repeat procedure for attaching remaining
door jamb at RIGHT side. See Diagram 15A.
LEFT
FRONT
WALL
SHEET
RIGHT
FRONT
WALL
SHEET
NOTE:
Full
wall sheet
shown
FRONT
Diagram 15
LEFT
CORNER
PANEL
ALL SCREWS
FITTED IN
SEQUENCE
SHOWN IN
DIAGRAM 11A
NOTE: FRONT WALL SHEETS are ONLY relevant to 8' wide and 10' wide sheds and MUST
be attached prior to the door jambs. Refer to Page 20, Diagram 12 to see which size wall sheet
applies to the shed size you are assembling.
FRONT WALL SHEETS & DOOR JAMBS
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H