Installation Guide

FRONT
BACK
FIRST RIDGE
OF RIGHT
BACK CORNER
PANEL
Refer to Diagram 11. Fit one full wall sheet (or one
half wall sheet, depending on the depth of your shed)
overlapping the first ridge of the RIGHT BACK
corner panel and secure to the top, middle
and bottom rails/brace, using screws,
and following the numerical order
shown in Diagram 11A.
Depths of sheds will vary.
Count the number of wall sheets in
carton to determine your specific
configuration and refer to Diagram 12.
ALL SHED SIZES:
Step 11
WALL SHEETS
Depth of sheds will vary.
Count number of wall sheets
in carton to determine your
specific configuration.
IMPORTANT:
Each sheet must be secured as per the
sequence shown in Diagram 11A
BEFORE fitting subsequent sheets.
Diagram 11A
Fit screws in this order
for all wall sheets:
NOTE:
Full wall sheet
shown here.
Bottom row, Top row,
Middle row, starting left
to right.
TOP
ROW
MIDDLE
ROW
BOTTOM
ROW
4
3
2
1
11
1
0
12
9
7
8
6
5
8' WIDE x
6' DEEP SHED:
EXAMPLES OF WALL SHEET CONFIGURATIONS
FOR 3 SHED SIZES - BACK & FRONT (width) & SIDES (depth)
6' WIDE x
5' DEEP SHED:
10' WIDE x
8' DEEP SHED:
BACK
FULL FULL
SIDES
FULL FULL
BACK
FULL FULL FULL
SIDES
FULL FULL
1
/
2
FRONT
DOORS
BETWEEN
1
/
2
1
/
2
BACK
FULL FULL FULL FULL
SIDES
FULL FULL FULL
FRONT
DOORS
BETWEEN
FULL FULL
1
/
2
Diagram 12
If you are constructing a shed
that is a different depth to the
ones shown, use Diagram 12
as a guide only.
IMPORTANT:
Starting at the BACK RIGHT SIDE of the shed:
Continue installing full wall sheets and
half wall sheets, as required, to complete
the right side of the shed.
IMPORTANT:
Follow Step 11A and Diagram 12A (see
next page) for fitting the last wall sheet at the
right side to the RIGHT FRONT
CORNER PANEL.
WALL
SHEET
WALL
SHEETS
Diagram 11
ALL SCREWS
FITTED IN
SEQUENCE SHOWN
IN DIAGRAM 11A
2
1
20
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H