Installation Guide

Step 10A
ROOF BEAMS (continued)
ROOF STRUTS
For 10' WIDE SHED ONLY:
Follow the steps on this page for attaching
the two Mid Roof Beams and two Roof Struts.
MID ROOF BEAMS
Fit the two mid roof beams to the left and right
gable brackets on both gables and secure
using one screw in each bracket.
See exploded view below.
IMPORTANT:
Ensure holes along the top edge of mid roof beams
are facing upward.
LEFT MID ROOF BEAM
FITTED TO
BRACKET
SCREW
RIGHT
MID ROOF
BEAM
BRACKET
RIGHT
MID ROOF BEAM
BRACKET
RIGHT
MID ROOF BEAM
ROOF
BEAM
Diagram 10
ROOF
BEAM
ROOF
STRUT
NUT & BOLT
INTO ROOF BEAM
& STRUT
NUT & BOLT
INTO GABLE
FLANGE
& STRUT
Attach a roof strut to one side of
the gable flange, and slide the strut up
into the centre groove of the roof beam.
Secure using nuts and bolts.
See Diagrams 10 and 10A.
Repeat for other end.
Diagram 10A
STRUT
IN GROOVE
AT BOTTOM
OF ROOF BEAM
ROOF
BEAM
CENTRE GROOVE
END VIEW
HOLES
FACING
UPWARD
IMPORTANT: TIGHTEN ALL NUTS AND BOLTS
IN THE ROOF BEAM ASSEMBLY NOW.
19
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H