Installation Guide

IMPORTANT:

For 6' wide & 8' wide sheds ONLY

TIGHTEN ALL NUTS AND BOLTS

IN THE ROOF BEAM ASSEMBLY NOW.

CENTRE

GROOVE

FLANGE

ROOF BEAM

ASSEMBLY

HOLES

FACING UPWARD

GABLE

ASSEMBLY

Diagram 9

VIEW FROM INSIDE

6' Wide Shed

Step 10

This step uses a pre-assembled component.

Fit the roof beam assembly to the inside

FRONT gable by slotting the centre groove

of the roof beam over the flange of the gable

assembly, as shown in Diagrams 9 & 9A.

IMPORTANT:

Ensure holes along the top edge of the

roof beam assembly are facing upward,

as shown in Diagram 9.

Secure using one nut and one bolt

through the roof beam. Do not tighten.

Repeat the procedure for the opposite end

and secure.

ROOF BEAMS

Note: For 10' WIDE SHED:

Follow this step using the pre-assembled Roof Beam,

then follow step 10A for attaching the two Mid Roof Beams.

ROOF

BEAM

CENTRE GROOVE

END VIEW

FLANGE IN GROOVE

AT BOTTOM OF ROOF BEAM

Diagram 9A

ROOF BEAM

IN POSITION

6' Wide Shed

FRONT

GI00034 November 1 2014

E N G L I S H