Installation Guide

Step 3
Step 4
Fit one corner panel to the base rail outer edge in the
FRONT RIGHT CORNER as shown in Diagram 2.
IMPORTANT: WIDER face of panel
MUST FACE FRONT.
Secure with
three screws in
numerical order
as shown in
Diagram 2.
IMPORTANT:
Bend these panels to a 90 angle by following the instructions
and diagrams to the right.
Corner panels are supplied bent to a 135° angle.
°
Lay the panel on a non-scratch
surface and carefully form the
angle to 90° by slowly working
along the panel and bending it
as you go. See Diagrams A - D.
IMPORTANT: DO NOT
OVER BEND PANEL.
IMPORTANT: Throughout these instructions fit screws
in the order shown (where applicable).
RIGHT
SIDE BASE RAIL
LEFT
SIDE
BASE RAIL
FRONT
BASE RAIL
Diagram 2
Diagram B
Diagram A
BACK
FRONT
RIGHT
CORNER
FRONT
CORNER
PANEL
(AT RIGHT
CORNER)
2
3
1
FIT SCREWS
IN THIS ORDER
Repeat the procedure for the second corner panel
at the BACK RIGHT CORNER, ensuring WIDER face
of the panel faces the BACK. See Diagram 3.
Then fit one side mid-wall brace to the two
corner panels at the centre hole position,
and secure using a screw at each end of
the mid-wall brace. See Diagram 3.
IMPORTANT:
Holes at each end on the thin face
of the side mid-wall brace MUST
face upward.
Diagram 3
1
BACK
FRONT
SIDE
MID-WALL
BRACE
HOLES
ON THIN FACE
MUST FACE
UPWARD
WIDER FACE
MUST
FACE BACK
CORNER
PANEL
RIGHT
SIDE
BASE RAIL
BACK
BASE RAIL
2
3
4
5
2
3
1
FRONT
BASE RAIL
RIGHT
SIDE
BASE RAIL
FRONT
CORNER
PANEL
WITH WIDER FACE
AT FRONT
2
3
1
14
CORNER PANELS
135°
90°
Diagram C
Diagram D
CORNER PANEL
END PROFILE
AS SUPPLIED
FOLDED TO REQUIRED ANGLE
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H