Installation Guide

Diagram 7
SIDE TOP-WALL
RAIL
SCREW
SCREW
SIDE
TOP-WALL
RAIL
WITH LEFT
TOP RAIL
BRACKET
INSERTED
LEFT
TOP-WALL RAIL
BRACKET
RIGHT
TOP-WALL RAIL
BRACKET
Pre-Assembly
TOP-WALL RAILS
(ii)
Using one of the top-wall rails, slide the corresponding top-wall rail brackets
into each end as shown in Diagram 7 below.
Then secure each end with a screw as shown.
Repeat using remaining top-wall rail and
the two top-wall rail brackets.
Place the two roof beams together
so the holes on the vertical
face on each beam line up.
Secure the two roof beams
together using five nuts
and bolts in the hole
positions as shown
in Diagram 6.
IMPORTANT:
DO NOT tighten nuts
and bolts at this stage.
(i)
(ii)
ROOF BEAMS
IMPORTANT:
10' wide shed only:
Also leave the two holes
second in from the ends empty.
These will be used in a later step.
Diagram 6
2 x
ROOF BEAMS
WITH HOLES
LINED UP
IMPORTANT:
10' wide shed
only:
LEAVE THESE TWO HOLES
EMPTY
11
© Globel Industries Pty Ltd
GI00034 November 1 2014
E N G L I S H