Use and Care

Page6
Installation
UNPACKING
Unpackthemixerimmediatelyafterreceipt.Ifthemachineisfoundtobedamaged,savethepackagingmaterial
andcontactthecarrierwithinfteen(15)daysofdelivery.Immediatelycontactyoursourceoftheequipment.
You have no recourse for damage after fteen (15) days.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYSinstallequipmentinworkareawithadequatelightandspace.
• ONLYoperatethemixeronasolid,LEVEL,non-skidsurfacethatisnonammable.
• NEVERbypass,alter,ormodifythisequipmentinanywayfromitsoriginalcondition.Doingsomaycreate 
 hazardsandwillvoidthewarranty.
• NEVERoperatethemixerwithoutallwarningsattachedtoit.
• DO NOTattempttoliftthemixeralone.
INSTALLATION
1. Readthismanualthoroughlybeforeinstallationandoperation.DONOTproceedwithinstallationand 
 operationifyouhaveanyquestionsordonotunderstandanythinginthismanual.Contactyourlocal 
 representativeorGloberst.
2. Removethecorrugatedboxfromtheskidbyremovingthebandsonthebox.NOTE:TheSP62PandSP80PL
 areshippedinawoodencrate;onlytheboltsatthebottomofthecrate(allfoursides)needtoberemoved.
3. Carefullyunboltthemixerfromtheskidusingan11/16”or3/4”wrench.
4. Selectalocationforthemixerkeepingthesepointsinmind:
 • Floororcountermustbelevel.
 • Easyaccessformaintenanceandservice.
 • Clearanceforoperatingcontrols,installingandremovingagitators,bowl,orattachments.
 • Sufcientspaceforaddingingredientsduringmixingperiods.
 • Ensurerearventilationoutletofmixerisnotblocked.
5. Useatleasttwootherpeopletotilttheunitandinstalltherubberfeet.
6. AboltdowntemplateandboltsareavailablefortheSP10,SP20,orSP25.ContactGlobeifneeded.
7. Inspectthemixertoensureallpartshavebeenprovided(i.e.bowl,beater,whip,anddoughhook).TheSP62P
 onlyhasabowl,doughhook,andbowltruck.
8. Readtheelectricalinformationfoundonthedataplatelocatedattherearofthemachine.Theincoming
 powershouldmatchtheratingonthedataplate.
CONNECTING TO ELECTRICAL POWER
Cord Connected Units: This machine is provided with a three-prong grounding plug. The outlet that
this plug is connected to must be properly grounded. If the receptacle is not the proper grounding type,
contact an electrician. Do not under any circumstances cut or remove the third ground prong from the
power cord or use any adapter plug. Never use an extension cord. Low amp supply could damage the
mixer or cause a re.