SP8 Owner's Manual

Page 7
Operating Instructions
TO AVOID SERIOUS PERSONAL INJURY:
• DO NOT operate mixer before reading the instruction manual rst.
• ALWAYS disconnect or unplug electrical power before cleaning, servicing, or adjusting parts or attachments.
• ALWAYS keep hands, hair and clothing away from moving parts.
ATTACHING BOWL TO MIXER
NOTE: Install bowl BEFORE attaching agitators.
1. Lower bowl by pushing bowl lift lever backward and down to its resting position.
2. Lift bowl by bowl handle.
a. Slowly position the locking pin (located on rear of bowl) into hole in the middle rear
of cradle (Fig. 7-1).
b. Lower bowl onto pins located on either side of bowl cradle.
3. Once bowl is positioned on cradle, secure bowl by pulling both bowl clamps forward until bowl is
locked tight (Fig. 7-2).
ATTACHING AGITATOR TO MIXER (i.e., Beater, Hook, Whip)
NOTE: It is easier to install agitator before adding ingredients into bowl.
1. The bowl must be in lowered position and splash cover must be removed (Fig. 7-3).
2. Slide agitator slowly upwards onto planetary shaft, tting shaft pin through the slot in agitator
(Fig. 7-4).
3. Rotate agitator clockwise to secure it onto planetary shaft (Fig. 7-5).
MIXING INGREDIENTS
Follow the capacity chart located on page 12 in this owners manual.
Overloading or not following this chart will damage mixer and void the warranty.
IMPORTANT: Make sure the speed control lever is on the rst (1) speed.
Fig. 7-1
Fig. 7-2
Fig. 7-3
Fig. 7-4
Fig. 7-5