PC User Program Manual

Page 38
Operation Explanation
Standard restore or
scale-to-scale copy
Select to restore the PLU and other scale operational data only. This only restores the
data types indicated by a check mark in the lower half of the screen. This option omits
data that is time-dependent (such as production data which would be out of date) or
specictoanindividualscale(suchasthethermalheadconguration).
Special full restore Select to restore all data to the scale. This option is typically used to restore a scale
that has lost all its data due to a fault or other reason. For example, if the main circuit
board has been replaced.
Custom Select to specify yourself which data to restore. In this case, select the restore data
using the check boxes in the lower half of the dialog.
Figure 38-1
The operation and explanation for each Restore Scale Data option is described below:
6. Select one of the Restore Mode options to specify the type of restore to perform. See Figure 38-1.
Note: Globe Food Equipment recommends that you ALWAYS choose “Special full restore” for ALL
restore operations. At the very least, make sure the “Scale Conguration” box in column 2 is
ALWAYS checked.
7. Select OK to start data transfer to the scale.
Note: A dialog box will appear displaying the progress of data transfer. The transfer can take a few
minutes, depending on the volume of data on the scale.
8. Adialogboxwillappearwhendatatransfernishes.Thiscompletestherestorationofthescaledata.
Note: If any errors occur during communications with the scale, an error message will appear. In this
case the backup will not be performed.