Soup Warmer Owner's Manual
Page 8
OPERATING SOUP WARMER
Before operating soup warmer, it should be checked to see that it is sitting level.
NOTE: Always wipe down outer surface of inner
pot before placing it inside warmer. Any
moisture remaining on inner pot surface may
cause a crackling noise while unit is heating
up. Except for actual cooking area, keep all
surfaces dry to prevent damage to the inner
workings of the appliance while it is in operation.
• Wash inner pot and lid in warm soapy water. Rinse and dry thoroughly.
• Never immerse outer pot in water.
• Always place inner pot inside base before plugging in soup warmer.
• When plugging in soup warmer, always be sure base pot contains at least 2.5 cups of water.
NOTE: When using soup warmer in higher altitudes add more water to soup warmer base.
• Save these instructions and refer to them often.
USE:
1. Connect the appliance to the main power supply. NOTE: NEVER place empty inner warming pot into soup
warmer base without water.
CAUTION - To make sure continued protection against risk of electric shock, connect to properly grounded
outlet only. If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualied person in order to avoid a hazard.
This equipment is for COMMERCIAL USE ONLY - See Diagram above for visual instructions.
2. Pour water into base of soup warmer no higher than the maximum water line marked on the inside of the base.
Make sure to check the water level of the warmer every 3 hours or so. Turn off unit, let cool and rell as needed.
Safeguards & Safety Instructions
Operating Instructions