Soup Warmer Owner's Manual

Page 5
Installation
UNPACKING
Unpack soup warmer immediately after receipt. If machine is found to be damaged, save the packaging material
and contact the carrier within fteen (15) days of delivery. Immediately contact Globe or your local dealer of the
equipment. You have no recourse to damage after fteen (15) days.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYS install equipment in a work area with adequate light and space.
• ONLY operate on a solid, level, nonskid surface that is nonammable and away from sinks and water hazards.
• NEVER bypass, alter or modify this equipment in any way from its original condition. Doing so can create
hazards and will void warranty.
• NEVER operate soup warmer without all warning stickers in place, including sticker attached to line/cord.
PROPER GROUNDING
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO WHICH THIS
PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE PROPER
GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD OR USE ANY ADAPTER PLUG (Fig. 5-1
and Fig. 5-2).
Plug the warmer into a properly grounded outlet only.
1. Complete warranty registration online at www.globefoodequip.com/support/warranty-registration-form.
2. Soup warmer and outside covering/containment unit will become HOT during and after use. Use caution when
touching the unit.
SAVE THESE INSTRUCTIONS
Power Cord:
• A shorter power cord is provided to reduce risk of someone becoming entangled or tripping.
• Proper use of extension cord, if required.
1. The extension cord must be a grounding-type 3-wire cord: the marked electrical rating of extension cord
must be at least as great as the electrical rating of the appliance
2. The cord must be arranged so that it will not drape over countertop or tabletop where it can be pulled on by
children or tripped over.
3. Check local re and safety ordinances before using an extension cord.
DO NOT USE if power cord or extension cord is damaged.
Fig. 5-1 Correct
Fig. 5-2 Incorrect