Manualshelf

C24CB SR and C36CB SR Chefmate Gas Charbroiler Owner's Manual

ManualsBrandsGlobe ManualsCommercial CharbroilersC36CB-SR Chefmate 36" Gas Charbroiler with 3 Burners, up to 105,000 BTUs, Stainless Steel Radiants and LP Conversion Kit in Stainless Steel
12345678910
Page 9
• DO NOT use any abrasive or ammable cleaning uids.
• DO NOT hose down, immerse or pressure wash any part of the charbroiler, excluding the catch tray.
• NEVER use a scrubber pad, steel wool or abrasive material, or cleaners containing chlorine, iodine and
ammonia or bromine chemicals as these will deteriorate the stainless steel and shorten the life of the unit.
WHEN CLEANING THE BURNER OF THE CHARBROILER, THE MAIN GAS VALVE MUST BE
SWITCHED TO THE CLOSED POSITION. AFTER CLEANING, THE GAS LINE CAN BE SWITCHED
BACK TO THE OPEN POSITION. PLEASE FOLLOW THE LIGHTING INSTRUCTIONS IN THIS MANUAL
TO RELIGHT THE CHARBROILER’S PILOT LIGHTS.
RECOMMENDED CLEANING
It takes very little time and effort to keep the charbroiler attractive and performing at top efciency. Wait at least one
hour for the unit and grates to cool after the unit has been turned off. Please follow the cleaning steps below:
PART REQUIRED ACTION FREQUENCY
Body Use a clean cloth and a non-abrasive cleaner to clean the stainless
steel body of the charbroiler.
Wipe the polished areas with a soft cloth.
Daily
Controls Unit should be turned off when not in use.
It is recommended that the unit be disconnected from the gas supply by
closing the main gas valve.
Use a clean cloth to wipe down controls and/or knobs
Daily
Grates and
Radiants
Caution: When handling grates/grids or radiants, always use
insulated gloves to prevent burns.
• Place grates on broiler facing down with grid bars horizontal.
• Turn the broiler on for approximately 45 minutes.
• Turn off the broiler and allow it to cool for 20 minutes.
• Clean top and bottom surfaces of grates with a wire brush to remove
animal fats and carbonized grease.
• Clean channels on grates with a scraper.
• Remove grates from broiler. Clean top surface of radiants with the wire
brush. They may be cleaned in place.
Warning: Do not cover the top of the grid grates during a burn off
operation. Restricting the airow by covering the grid grates may cause
them to warp. It will also cause damage to the valves, the knobs and the
front panel decal.
Daily or as needed
Cleaning Instructions