C9, C10, C12 NEW C Series Chefmate Slicer Manual (NSF 2010 Cert)

Page 7
Installation
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO
WHICH THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS
NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY
CIRCUMSTANCES, CUT OR REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD OR
USE ANY ADAPTER PLUG (Fig. 7-1 and Fig. 7-2).
5. Inspect the slicer to ensure all parts have been provided.
6. Make sure the knife cover, knife ring guard, and knife sharpener are in place.
7. Make sure the warning label is properly positioned and legible and the instruction manual is available near
the slicer.
8. Complete the warranty registration online at www.globeslicers.com/warranty.asp.
9. Post the provided wall chart in a visible area near the slicer to be referred to often for cleaning, sanitizing,
and inspecting your slicer. Refer to this wall chart and the Owner’s Manual for proper cleaning, sanitizing
and inspection of your slicer.
10. Clean the slicer using the procedures outlined in the cleaning section (pages 10 and 13) prior to using the
slicer.
11. Contact your local representative, or Globe directly, if you have any questions or problems with the
installation or operation of this slicer.
Figure 7-1 Correct Figure 7-2 INCORRECT