User's Manual

CONNECTING INSTRUCTIONS
QR
QR
Please keep these instructions






Don’t have a barcode?
Select "Don't have a barcode?" in the Alexa app and follow the in-app instructions on how to connect without a 2D barcode.

If you are struggling to set up your device, or if the device was already connected to a network, perform a factory reset by following the
instructions below:
1. Turn device ON for 10 seconds.
2. Turn device OFF and ON 5x. The light will flash RED and then the light will change to WHITE. When the light changes to WHITE, this means the
factory reset mode was successful.
3. Scan the inner barcode (located in the instruction manual) and connect within 5 minutes. If you fail to connect within the 5-minute time frame, turn
device OFF and ON again once to re-enter pairing mode.
The light will flash WHITE to indicate that the pairing was successful.


Ensure your device has been installed correctly by following the instructions in the “Installation” section.

• Launch the Amazon Alexa app.
• Select “Add a Device”.
• Select “Light”, locate Globe Electric and follow the in-app instructions on how to scan the 2D barcode.
Please note:
The device is automatically in pairing for 5 minutes once powered on. When you scan the barcode, the white light will flash indicating the pairing is
successful. If within 5 minutes, it does not connect, turn the device OFF and ON again to re-enter pairing mode.