Instructions / Assembly

SAFETY
Most electrical accidents are caused by carelessness or ignorance. If you combine a basic knowledge of electricity, a
healthy respect for it, and a dose of common sense, you can safely tackle many household electrical repairs. Here are
some basic guidelines for working with electricity:
1. Before working on a circuit, go to the main service panel and remove the fuse or trip the breaker that controls that
circuit. Tape a sign to the panel warning others to leave the circuit alone while you work.
2. Before touching any wire, use a voltage tester to make sure it’s not live.
3. Whenever you check for voltage in a receptacle, check both outlets — each may be controlled by a separate wiring
circuit.
4. When replacing fuses, turn off the main power first. Make sure your hands and feet are dry, and place one hand
behind your back to prevent electricity from making a complete circuit through your chest. Touch a plug fuse only
by its insulated rim. Remove cartridge fuses with a fuse puller.
5. Use tools with insulated handles and ladders made of wood or fibreglass.
6. To protect children, place safety covers over any unused outlets.
7. When unplugging a power tool or appliance, pull on the plug, not on the power cord.
8. Improperly-used extension cords are a leading cause of electrical fires. They are for temporary use only — do not
use them to extend a circuit permanently.
9. Keep dry-chemical fire extinguishers in the kitchen, basement, and workshop.
10. Never disable grounding devices. Make sure that all appliances requiring grounding are properly grounded, and
ensure the electrical system itself is properly grounded.
11. Meet or exceed all electrical code requirements that cover the work you are doing.
12. Always work with enough light to see what you are doing; it’s easy to make mistakes when you’re working in dim
light.
13. When in doubt about the safety of any electrical repair or test, call in a professional.
NOTES
• Lamp may not be compatible with all dimmers – for more information on dimmer compatibility visit
www.globe-electric.com.
• This Class B digital apparatus complies with CAN ICES-005(B).
• This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
• Not for emergency lighthing
ENGLISH