Instructions / Assembly

20
GWS USA, Bradenton, FL, USA • [e-mail] • [phone] • www.gwsusa.com
INSTALLATION ET SCHÉMA
Séries PressureWave™ et PressureWave SF™
INSTALLATION DE PLUSIEURS
RÉSERVOIRS
All tanks must have the same pre-charge for the system to
function properly. Tanks should be installed on a header to
ensure all tanks receive equal and balanced pressure. Adjust
each tank pre-charge as detailed in the adjusting tank pre-
charge section. The system pressure switch or control should
be centrally located (see Figure 2.1 & 2.2) in order for the tanks
to function properly.
Fig. 2.1
Fig. 1.4 Booster pump with horizontal tank
Fig. 1.5 Booster pump with inline tank
Fig. 2.2
If you have a jet pump, to prevent
damage to the well system, close
or plug the opening during tank
installation where the installation where
the vacuum and air volume controls
connect to the pump and/or piping.
Fig. 1.3 With convertible jet pump