Operation Manual

26
 6. Removethefinderscope(F) with thebracket
for the finder scope (E) from the packaging.
Thenunscrewthetwoknurledclampingscrew
from the telescope tube (G). Place the finder
scopeontothetelescopetube,suchthatthe
drillholesinthebaseofthefinderscopeover-
lap with the open threaded drillholes. Insert
thetwoknurledclampingscrewsandtighten
these.(Fig.6)
 7. Insertthedeflectionmirror(C)indentubedrive
forsettingthesharpness(B).Fitthedeflection
mirrorintothetubewiththeappropriatelocking
screws,andtightenfirmly.(Fig.7).
 8. Insert the eyepiece (D) into the deflection
mirror(C).Theeyepieceisalsofastenedwitha
smalllockingscrew.(Fig.8).
 NOTE: This image appears upright, however
itisamirrorimage.Inordertoobtainatrue-
sidedimage,removethedeflectionmirrorand
insertthecorrectivelens.
 9. Specialaccessoriescorrectivelensandmoonfilter.Insertthecorrectivelensasdescribedin
Point8.Themoonfilterisscrewedintotheeyepiecethread.
10. Byusingseverallenses,thesharpnesssuffers.Itisnotrecommendedtousethedeflection
mirror together with the erecting lens (quality loss). The highest resolution is achieved
whennotusingadditionallenses.Iftheadjusteronthetubeshouldnotbesufficient,you
have additional adjustment options if you loosen the eyepiece locking screws, pull the
eyepieceoutslightlyandthentightenthescrewsagain.
Yourtelescopeisnowfullyassembledandreadytouse.Usethestarchartonthebackofthe
packaginginordertobeabletooptimallyadjustyourtelescopeandenjoyit.
CAREFUL:Observingthesuncanresultinpermanentdamagetotheeyes.Neverlookatthesun
withthefinderscopeorevenwiththenakedeye.