Operation Manual

25
INSTRUCTIONS FOR USE
1.Pull out the three tripod legs (P), and set
thesesecurelyintherequiredpositionwiththe
collapsiblebrackets(1).(Fig.1).
NOTE: Before assembling the tripod legs, ensure
thatthecollapsiblebracketsoneachtripodleg
arepointedinwards.Theaccessorytray(N)of
thetripodisattachedtothesebrackets.
2.Fasten the three tripod legs with the wing nuts
andthethreadedbolts(2)tothetripodhead
(M). Before tightening the wing nuts, ensure
thatyouhaveinsertedawasher.(Fig.2).
3.Now attach the accessory tray (N) With the
suppliedthreadedboltsandwingnutstothe
bracketsonthetripodlegs.(Fig.3).
NOTE: The tray bracket can be pushed in acces-
sorytrayfrombelow,afterassembly.(Fig.3).
4.After you have tightened all of the screws, the
telescopetubecanbeinsertedintothefork(K)
of the tripod head. Insert the telescope tube
(G)intothefork(K),andsecureitbyadjusting,
usingthelargefork-securingscrew(J).(Fig.4).
5.Insert the pin of the vernier vertical adjuster
(R)intothescrewmountingontheazimuthal
mounting. Connect the other end of the pin
tothemainbodyofthetelescope.Fastenthe
vernier adjuster by tightening the screw and
therotaryknob.(Fig.5).